hotend - K-Thermistor vs Ender 3 Stock Thermistor: Problem with

I have changed my hotend on my Ender 3 v2 with Dragonfly BMS. In effect, because I wanted to reach higher temperatures, I also changed the thermistor with one that is 3mm wide and does not have the

Elves Ender 3 S1 Thermistor Sensor， CR10 Smart Pro, Sermoon V1 Pro 3D Printer Hotend Replacement Parts Thermistor Temp Sensor Compatible with Sprite Extruder Heater Block（3 Pack） : Industrial & Scientific

The heating tube has XH2.54 interface, and the resistance has XH1.25 interface, which is easy to replace and install. Compatible Models: Ender 3 1S

Creality Ender 3 S1 Pro Heating Tube and Thermistor, 24V 50W Heating Tube Thermistor Kit for Ender 3 S1 Pro, CR-10 Smart Pro (Heating Tube+Thermistor)

Ender 3 V2 - replaced thermistor, still beeping and saying nozzle is too lowperture after several hours of printing. How can I fix this? : r/FixMyPrint

Serious problem!! Is my thermistor broken? : r/ender3

Dragon hotend breakage (my fault), So until I get parts, it is now part stock (heatbreak/heatsink) & part dragon (heatblock, v6 nozzle) to use the cartridge thermistor, too lazy to put the

Wire Length: 51.1inch /1.3m. The package includes 5 3D printer thermistors. 2-pin XH2.54 female connector. Note Before Buying: Our Ender 3 thermistor

5PCS Creality 3D Printer NTC Thermistor 100K, NTC 3950 100K ohm Thermistor Temp Sensor for Creality Ender 3/Ender 3 Pro/Ender 3 Neo/Ender 3

Hotbed thermistor problem AGAIN : r/Sovol

Revo Micro Ender 3/CR10 upgrade guide – E3D Help Centre

Upgrade HT-NTC100K Thermistor: package temperature measurement. Temperature measurement head cylinder diameter 3mm, length 15mm, can be used with the

FYSETC Prus i3 MK3 Upgrade Hotend Parts HT-NTC100K Thermistor Sensor High Temperature +250 Degrees 2 Pins for 3D Printer MK3 Extruder Heater Block