The DTI (Dual Transformer/Isolater) is a high quality totally passive audio interface that uses a pair of high performance transformers to totally separate input and output signal grounds, thereby isolating two systems and reducing hum and ground-loop noise. The DTI’s audio transformers have an extremely flat and wide
The DTI (Dual Transformer/Isolater) is a high quality totally passive audio interface that uses a pair of high performance transformers to totally separate input and output signal grounds, thereby isolating two systems and reducing hum and ground-loop noise. The DTI’s audio transformers have an extremely flat and wide frequency response and can handle high signal levels while an isolated balanced output. This gives the DTI a very clean and neutral sound with a wide variety of maintaining signal sources. The transformers are wound for 1:1 unity gain and are designed to be used with impedances from 600 ohms to 100k ohms.
What further sets the DTI apart from other lesser isolation boxes is its connection versatility. We have provided XLR, 1/4″ phone, and RCA type phono connections on all inputs and outputs. This allows it to easily fit into virtually any audio system and be the clean patch point between all types of systems. Whether you need an interface between a computer based audio workstation and your monitor system, isolation on long cable runs in a fixed installation, isolation of a signal source from your recording equipment, or in many cases, just a safer connection between two audio systems, the DTI can accommodate. The compact black anodized all aluminum case and it’s passive design allow the DTI to provide years of trouble free service in Live Sound, Permanent/Fixed Install, D.J., and virtually any PA application. It’s full feature set, rugged construction, and high-end specifications make the DTI the obvious choice.
Hum in an audio system is often caused by loop effects which act like antennas. These loops can easily pick up a 60 Hz (or higher harmonics) hum transmitted by electrical wiring. Typically, these loops are connected via grounds, more commonly called ground loops. The safest way to eliminate unwanted noise is with the CleanBOX II. The CleanBOX II easily removes ground loops without any signal degradation.
Art - CleanBOX II (Hum Eliminator)
Hum in an audio system is often caused by loop effects which act like antennas. These loops can easily pick up a 60 Hz (or higher harmonics) hum transmitted by electrical wiring. Typically, these loops are connected via grounds, more commonly called ground loops. The safest way to eliminate unwanted noise is with the CleanBOX II. The CleanBOX II easily removes ground loops without any signal degradation.
Art - CleanBOX II (Hum Eliminator)
Convenient and Versatile - Connect a wide range of audio equipment, from instruments and mixers to computers and home theater systems, with this TRS
TNP Premium 1/4 Inch TRS to Dual RCA Audio Cable (10FT) - Male 6.35mm 1/4 TRS to 2RCA Connector Wire Cord Plug Jack
ART DTI Dual Transformer Isolator Hum Eliminator : Industrial & Scientific
ART DTI - Dual Input Inline Transformer/Isolator Box with Balanced and Unbalanced Connectors Inputs 1/4 TS XLR 3 Pin, Outputs 1/4 XLR 3, Channels 2
Radial Engineering R8001112 ProAV1 Mono DI
Morley MHE 2-channel Stereo Hum Eliminator
Radial Engineering R8001100 ProDI Single Ch Passive DI Box
2-channel Hum Eliminator with XLR, 1/4, and RCA Inputs and Outputs
ART DTI 2-channel Hum Eliminator