Support pour pile CR2032 ADA1870 Adafruit - Connectique

Sewable CR2032 Battery Holder : ID 653 : $1.95 : Adafruit

Sewable CR2032 Battery Holder : ID 653 : $1.95 : Adafruit

This battery holder is by far the easiest way to add a battery to a small wearable project. By coincidence, there are two small 1mm diameter holes in the metal connection tabs, just large enough for a #5 or smaller needle to pass through. One tab connects to common ground (negative) and the other tab is +3 Volts. This holder is meant to be used with Lithium CR2032 (20mm diameter, 3.2mm thick) sized coin batteries. These are almost always 3V at about 200+ mAh capacity.

Adafruit Industries ADA653 Sewable CR2032 Battery Holder

This adorable little coin cell battery holder is great for small, portable, or wearable projects. It holds two 20mm coin cell batteries (also known as CR2032) in series to generate 6V nominal. 20mm coin cells are popular as they are used in keychain lights and remotes, so they are easy to get and fairly low-cost. They tend to have about 220mAh capacity. The housing is made of plastic and easily screws counter-clockwise to open and close.

Adafruit Industries ADA4988 2 x CR2032 Coin Cell Battery Box w/ On-Off Switch & Plain Wires

Adafruit 2 x 2032 Coin Cell Battery Holder - 6V output

Sewable CR2032 Battery Holder : ID 653 : $1.95 : Adafruit

adafruit-Single CR2032 / 20mm Coin Cell Battery Holder with Switch

20mm Coin Cell Breakout Board (CR2032) : ID 1870 : $2.50

Supports piles boutons

20mm Coin Cell Breakout Board (CR2032) : ID 1870 : $2.50

Adafruit Industries ADA783 2 x 2032 Coin Cell Battery Holder - 6V Output with On/Off Switch

Sewable CR2032 Battery Holder : ID 653 : $1.95 : Adafruit

Great for powering very low-current projects, or adding a battery backup circuit to a real-time-clock or similar Fully assembled and tested Simple but

Adafruit 20mm Coin Cell Breakout Board (CR2032) [ADA1870]